Key function:

• Suitable applications: adaptor / charger / LED driver / industrial SMPS / display panel driver / medical adaptor.

• Using programmable Electronic Load, and monitoring the electric parameters in real-time channel by channel: Voltage / Current / Power

• Professional software. Free to update in all life.

• Programmable the model parameters, test items, SPEC, aging time, and ON/OFF schedule. The voltage can be auto selected and ON/OFF switch. The load condition could be changed in all aging schedule.

• Close system power automatically after aging finished. No-human needed..

• Test result auto judged by computer. Several aging vehicles can be monitored in one system and saving operators.

• All test data stored automatically. Test report generated automatically.

• Support Bar-code scanning, have interface with MES system.

• Each computer can simultaneously monitor 18 aging vehicles (each serial port can used to monitor 63 devices max, each computer supports up to 18 serial ports)

Aging cabinet parameters：

• Demission:  L2050*W880*H1900 (mm), Total 6 layers, 170mm height between each layer.

• Four folding glass doors. Products area can be heat to 60 degree.

• 380V three-phase power with five wire distribution; Support computer control modes and manual control modes. These two modes can be switched manually or automatically.

• Input AC voltage display, start switch, emergency stop switch.

• Equipment grounding protection, leakage protection, smoke alarm and automatic power-off protection etc.

• 192 isolation channels

Electronic Load parameter:

• 4 channels isolated. Support to test isolated or non- isolated power supply, several outputs power supply.

• Parameter: 100W/500V/10A per channel, accuracy:0.5%

• Support 5 load modes: CC (constant current), CV (constant voltage), CR (constant resistance), CP (constant power), LED(simulation LED cell)

• Each channel can be used in parallel to get large power or high voltage / current..

• Real LED cell can be well simulated in LED modes, so we can get accuracy parameters when we test LED driver.

• Support ripple voltage and ripple current test (ripple frequency below 10KHZ).

• Support Von/Von latch set.

• OTP / OCP / OPP

• Demission: (L*W*H/mm):180 * 110 * 90

• No E-capacitor, no relay, long life type design